The rear axle is in a bit of a state. It covered in surface rust and i can feel play or slop in the differential. It needs a strip and rebuild. I will try to re-use as many components as i can, but all seals, washers, and gaskets will be replaced. Bearings will be assessed and most likely replaced.
First off were the springs, this took all the remaining time i had, so that's all that got done!
Here a nice shot of all the new metal on the drivers side.
I rolled the shell back on its side again to give more space and access to the boot floor which will soon come out.
No comments:
Post a Comment